73-87chevytrucks.com
73-87 Chevy _ GMC Trucks => Body, Glass & Paint => Topic started by: Laderhosen on November 13, 2010, 01:54:44 pm
-
Does anyone know if Sherman part 923-60L which is listed as 'QTR PNL RR SEC LH/RH SUBURB 73-91' will work on a Blazer. I'm most concerned about the angle of the bottom edge. Is it the same on a Suburban as on a Blazer???
I can't find any listed on their website specifically for Blazers....
http://shermanparts.com/ecat/base/dropdowns.php?last0=CHEV&last1=BLFS&make=CHEV&model=BLFS&year=1987
Sherman and parts are the only ones I can easily get hold of.
-
Right above it is the blazer/Jimmy listed as QTR PNL FT SEC LH 73-91 BLZ/JI
-
That's for the section that goes in front of the wheelarch though...??
-
Part # 898-53BL
Is that not the same part, just for the Blazer/Jimmy????
-
Part # 898-53BL
Is that not the same part, just for the Blazer/Jimmy????
No, click on the little blue square to the left of the part description and it shows a photo.....
-
All of those patch panels are listed as: Truck, Blazer & Suburban. You are correct, the bottom angle will be slightly steeper for the short bed truck, Blazer, ect., compared to the long bed & Suburban, however it should not be a problem...it will just "roll under" & you can cut it off flush with the existing portion of the panel. Lorne
-
The one I am talking about does not have a little blue square next to it...
-
All of those patch panels are listed as: Truck, Blazer & Suburban. You are correct, the bottom angle will be slightly steeper for the short bed truck, Blazer, ect., compared to the long bed & Suburban, however it should not be a problem...it will just "roll under" & you can cut it off flush with the existing portion of the panel. Lorne
Cool, but surely if I "roll under" the metal it'll make the angle even shallower?? Guess I'll have to roll it out and hopefully there'll be enough sheet metal....