73-87chevytrucks.com

73-87 Chevy _ GMC Trucks => Engine/Drivetrain => Topic started by: 86silverado on January 15, 2011, 05:28:52 pm

Title: Clutch Pedal Stays On floor
Post by: 86silverado on January 15, 2011, 05:28:52 pm

Went to drive truck the other day and pushed clutch down started truck and pedal stayed there, acts like it has no pressure at all, has hydraulic slave cylinder and manual throwout bearing,   Im sure its slave cylinder,(which was just replaced not that long ago, but just because its new doesnt mean it cant break)  is there anything else that could be wrong other than the slave cylinder?

Title: Re: Clutch Pedal Stays On floor
Post by: VileZambonie on January 15, 2011, 05:45:18 pm

Did you check the fluid in the clutch master cylinder??

Title: Re: Clutch Pedal Stays On floor
Post by: 1980c10 on January 15, 2011, 05:57:59 pm

clutch cylinder, slave cylinder or the line connecting the two could be bad. It may also need to be bled and fluid added.

Title: Re: Clutch Pedal Stays On floor
Post by: 86silverado on January 16, 2011, 12:03:30 pm

yeah i checked fluid and it was still full, throwout bearing was makin noise before, that mighta went bad too

Title: Re: Clutch Pedal Stays On floor
Post by: VileZambonie on January 16, 2011, 12:10:29 pm

If you bled it and it's not building pressure replace the master.