73-87chevytrucks.com

General Site Info => General Discussion => Topic started by: Blazin on January 27, 2013, 01:54:06 pm

Title: Shop project.
Post by: Blazin on January 27, 2013, 01:54:06 pm

Spraying 1,400' of V groove pine with urethane for a contractor buddy of mine.

(http://i136.photobucket.com/albums/q165/BlazinK30/Misc%20projects%202/0115131324.jpg)

(http://i136.photobucket.com/albums/q165/BlazinK30/Misc%20projects%202/0115131240.jpg)

(http://i136.photobucket.com/albums/q165/BlazinK30/Misc%20projects%202/0115131241.jpg)

(http://i136.photobucket.com/albums/q165/BlazinK30/Misc%20projects%202/0115131241a.jpg)

Title: Re: Shop project.
Post by: 84burb on January 27, 2013, 02:22:25 pm

That's a lot of truck beds...  ;D

Title: Re: Shop project.
Post by: DnStClr on January 27, 2013, 03:22:29 pm

I'd hate to sand it all down for the 2nd coat. :o

Title: Re: Shop project.
Post by: zieg85 on January 27, 2013, 03:32:35 pm

I was at a customer that does similar work on an automatic machine at 300 ft./min.

Title: Re: Shop project.
Post by: Blazin on January 27, 2013, 09:52:59 pm

First, and second coat one right after another. Stand it up long enough to spray them all, then start over again. Let them sit for about 4 hours, gave them a light scuff with 320 paper, wiped them with a rag, then a tack cloth, and spray a third heavier coat on.

Title: Re: Shop project.
Post by: PromiseKeeper on January 30, 2013, 12:18:58 pm

looks like the snow blade is going to benefit from the process as well!