73-87chevytrucks.com

73-87 Chevy _ GMC Trucks => Engine/Drivetrain => Topic started by: 75_chevy on January 28, 2014, 04:54:10 pm

Title: edel 8030
Post by: 75_chevy on January 28, 2014, 04:54:10 pm

is this supposed to mount to the intake? ever since I swapped carbs my linkage has been a little screwy and I couldn't get the pedal into full throttle as it was hanging up on the throttle kickdown cable. so I got this bracket but I can't seem to find where to mount it. looked everywhere maybe I'm just being an idiot but I'm not getting it.. :( (http://img.tapatalk.com/d/14/01/29/7atyhy2y.jpg)(http://img.tapatalk.com/d/14/01/29/yjybe6em.jpg)


Sent from my iPhone using Tapatalk

Title: Re: edel 8030
Post by: bd on January 28, 2014, 07:25:10 pm

Fastens under the two rear intake manifold bolts, driver's side.  Quite often, aftermarket brackets won't provide a perfect mounting or alignment solution for the cables without some tweaking.

Title: Re: edel 8030
Post by: 75_chevy on January 28, 2014, 08:57:12 pm

dang good to know thank you for the reply


Sent from my iPhone using Tapatalk

Title: Re: edel 8030
Post by: Irish_Alley on January 28, 2014, 11:21:52 pm

i have had to bend brackets to make them work.

Title: Re: edel 8030
Post by: 75_chevy on January 29, 2014, 12:56:49 pm

how far off were they?


Sent from my iPhone using Tapatalk

Title: Re: edel 8030
Post by: 75_chevy on January 29, 2014, 04:11:53 pm

got it (http://img.tapatalk.com/d/14/01/30/a7enuvu7.jpg)


Sent from my iPhone using Tapatalk

Title: Re: edel 8030
Post by: bd on January 29, 2014, 05:26:33 pm

Looks good!

Title: Re: edel 8030
Post by: 75_chevy on January 30, 2014, 11:49:45 pm

thanks! running so much better now too


Sent from my iPhone using Tapatalk