73-87chevytrucks.com
73-87 Chevy _ GMC Trucks => Interior & Equipment => Instrumentation => Topic started by: Chevhughes on March 01, 2015, 04:50:20 pm
-
1985 c20 stock 350 700r4 trans. Unmolested truck from Calif.
I pulled trans for a rebuild and that has been re-installed. I saw this wire while trans was out and could not see anywhere it may have been. I am finishing up replacing intake gaskets now. and still have nowhere for this wire. It is brown and it says 103 r on the boot. I am going to start looking thru my manual now but figured I would try here as well. Thanks for any help.
-
truck does not have a tach, it does not go to the distrib from what i can tell, and the wiring is on the oil press sensor..
-
That is for the oil sender...What does the wire look like that is on your sender? Does your truck have an original oil pressure gauge & does it work? Some had a light as well, I'm guessing this is the case. Lorne
-
Thank you for the response, my truck does not have a gauge. it has a light only, the pressure sensor has a plug that pushes on from the top and sorta clamps around the sensor, I don't know how the pics will turn out.
-
hmmmmm
-
That is an oil sending unit plug. Since you have the light it may be extra. Doesn't the gauged trucks T off and one is the oil sender and the other is for the electric choke?