73-87chevytrucks.com

73-87 Chevy _ GMC Trucks => Engine/Drivetrain => Topic started by: empire848 on September 04, 2015, 04:31:34 pm

Title: Stalls out in drive???
Post by: empire848 on September 04, 2015, 04:31:34 pm

Hey guys,
I just recently changed out the fuel sending unit in my 85 c10 350sb. After I finished everything I put about 6 gallons of gas in the truck and it ran fine  ;D . The next day I fired her up and went for a drive, for the first half hour she ran good. I went and got some more gas (about another 6 gallons) then she cut off in the middle of the road  >:( . Now she starts up fine when in park but when I throw her in drive she stalls out.  Anybody got any ideas, I would very much appreciate it.

Title: Re: Stalls out in drive???
Post by: zieg85 on September 04, 2015, 04:34:37 pm

Check your fuel filter

Title: Re: Stalls out in drive???
Post by: empire848 on September 04, 2015, 04:37:21 pm

Hey,
Fuel filter is new.

Title: Re: Stalls out in drive???
Post by: frotosride on September 04, 2015, 06:16:44 pm

+2 check the filter.. If the last thing you did was fill up on gas you could have gotten a lot of sediment. Pull off the new filter and blow through it reverse flow into a paper towel or shop rag.. Used compressed air if you've got it

Title: Re: Stalls out in drive???
Post by: blazer74 on September 04, 2015, 07:51:22 pm

Check it again.


Sent from my iPhone using Tapatalk

Title: Re: Stalls out in drive???
Post by: empire848 on September 04, 2015, 11:52:10 pm

Ok, will do in the morning.