73-87chevytrucks.com
73-87 Chevy _ GMC Trucks => Body, Glass & Paint => Topic started by: bowmank10 on October 04, 2015, 06:09:40 pm
-
Finally got around to putting the bed together on my 1980 k10. I bought two repop bed sides, which don't fit worth a dang and when I went to see if my tailgate fits, it doesn't of course. It seems like the bed sides are to close together and the tailgate doesn't fit between the two by about 1/4". Any ideas?
Sent from my XT1254 using Tapatalk
-
Have you welded the back of the bed yet? If you have welded the rear of the bedsides, cut the weld and mount the tailgate. You don't weld the rear of the bedside until after the tailgate is mounted. This is what I have been told. This way you can get the gap right on both sides. Good luck and I hope this helps.
-
I have not welded yet....bed sides are just bolted.
Sent from my XT1254 using Tapatalk
-
I would use a load lock or something like that to spread the bedsides apart until the gap is right. Then I would spot weld it and check for fitment. If you don't have a load lock use a 2x4 and a bottle jack or portapower .
-
loosen up bolts to floor , mount gate, place shims on each side to preferred gap, weld the floor to sides retighten bolts.
-
Ended up doing exactly what 87max suggested and now it fits pretty dang good...thankyou
Sent from my XT1254 using Tapatalk