73-87chevytrucks.com

73-87 Chevy _ GMC Trucks => Engine/Drivetrain => Topic started by: Redneckchevy on April 19, 2006, 08:17:00 pm

Title: tranny help
Post by: Redneckchevy on April 19, 2006, 08:17:00 pm

86 K10 4x4 4 speed with granny gear hydrolic.How hard is it to put a new clutch on this tranny? and what are the steps?  

Title: Re: tranny help
Post by: roundedline on April 21, 2006, 10:55:00 am

How experience are you with autos?

To get the clutch out you are going to have to remove the hydraulic lines to the clutch, remove the driveshafts, remove the trans crossmembers, remove/support the trans/transfer case, remove the bellhousing, remove the pressure plate/clutch, remove the flywheel.  Take the flywheel to get it turned and purchase a new clutch kit (pressure plate, clutch and throw out bearing).  And reverse the proceedure.

Chris Lucas
www.73-87chevytrucks.com
www.captkaoscustoms.com
Project Su
Jimmy 2WD Project

Title: tranny help
Post by: Redneckchevy on April 21, 2006, 09:36:00 pm

what to do with the transfer case? Remove it before the trany or remove it with the trany

Title: Re: tranny help
Post by: roundedline on April 26, 2006, 05:09:00 pm

I would remove it with the transmission.

Chris Lucas
www.73-87chevytrucks.com
www.captkaoscustoms.com
Project Su
Jimmy 2WD Project