73-87chevytrucks.com

General Site Info => General Discussion => Topic started by: 84 silverado on March 27, 2003, 10:43:00 pm

Title: parts still need to go away.....
Post by: 84 silverado on March 27, 2003, 10:43:00 pm

hey folks, I still have some extra parts from my project truck I need to part with. I have a new set of door weatherstrips(still in the bag), a Powertrax locker for a 8.5" ten bolt with 28 spline axles, and a fairly new edelbrock #1406 electric choke 600cfm carb with a NIB A/C Delco 14" breather. I'm trying to clean the rest of my garage out. It's all good stuff, the breather and the locker are unused, the locker is even installed in a carrier. I'd like to get $200 for the locker, $35 for the rubbers, and $150 for the carb and air cleaner. These are all pretty decent prices but it's less shipping. Anybody interested please jet me an email at WDALEX@aol.com. Thanks alot dudes and dudettes, Bill

Title: RE: Parts
Post by: collomzh on March 27, 2003, 11:10:00 pm

Where are you?

I am in the market for some.

Zach

I am in WA.

Title: parts....
Post by: 84 silverado on March 28, 2003, 08:43:00 am

I'm in Pensacola Florida..... the OTHER end of the country!!!!  

Title: Re: parts....
Post by: Eric 85K10 on March 31, 2003, 11:26:00 am

Put me down for the door rubber. I need some weather stripping bad. It might be a week or two before I can round up 35 bucks I'll send a check.  

Powertrax, thats a locker and not posi traction? I just need posi traction for my 10bolt..


btw, I'm in WA to, but I dont think the rubber will be hard to ship.

Title: parts-n-stuff
Post by: 84 silverado on March 31, 2003, 02:54:00 pm

Eric, the Powertrax is a locker that installs in your factory carrier in place of the spider gears. I bought it to use for a boat pulling deal but got another truck that already has a posi in it so this one is useless to me. It's already installed in a carrier too(that's how far I got with the project) but doesn't even have grease on it. I wouldn't think it would cost more than $5 or so to ship the rubbers to you either. Thanks, Bill

Title: Re: parts still need to go away.....
Post by: oscarone on April 03, 2003, 10:56:00 pm

Speaking of parts...I have got a brand ne set of rs9000 rancho's for "73-87", 4" lift.  $100 bucks plus shipping.  Also, a complete AIR kit (pump, pulley, diverter valve and stand, check valves and injection tubes).  All new, never installed.  $200 obo. ru4000@yahoo.com

Title: Re: parts still need to go away.....
Post by: RSBAD454 on April 04, 2003, 01:44:00 pm

you still have that door rubber?

Toys are my game

Title: parts.......
Post by: 84 silverado on April 04, 2003, 04:45:00 pm

I still have the door rubbers and a locker. Sold the carb and breather today along with a new bra. Woo-hooo, finally starting to see a spot on my floor. Now if my bike would go away I could start over!!!

Title: Re: parts.......
Post by: RSBAD454 on April 07, 2003, 11:47:00 am

how much for the door rubbers and are they GM?

Toys are my game

Title: Parts
Post by: EFF 83 on April 20, 2003, 10:25:00 pm

Do you still have the rubbers and what pieces are they?

I've never heard of a Powertrax locker. Is that like a spool? Is it for rear end of a 2wd drive truck or front end of a 4wd. Ive heard of lockers for 4wd. I was looking at putting an Eaton Posi with 3.73 in my rear end, Will the powertrax be better?

Title: parts
Post by: 84 silverado on April 22, 2003, 08:40:00 pm

I've sold everything but the locker to date guys, thanks anyway. I'll be deployed out of the country for the next six months or so it looks like so I'll still have it when I get back.