73-87chevytrucks.com
73-87 Chevy _ GMC Trucks => 73-87 Chevy & GMC Trucks => Topic started by: soiset on February 21, 2008, 06:06:22 pm
-
Hello, first post here. I have a beautiful 1984 Silverado 4x4 in Dallas that I bought from the first owner in Raleigh, NC. I've had it for 10 years now, and probably will have it forever.
Not too long ago, I ran into a bit of an emergency with the headlights. The switch had been gimpy for a while, but I'd always been able to wiggle it into working. I was about an hour away from home, on a craigslist run, and at dusk, I simply could not get the lights to come on. Hungry, tired, and a little cold, I quickly narrowed the problem to the switch, and came up with a quick fix. I pulled the wires out of the switch, did some experimenting, and hotwired my lights on. I made it back home.
Now, I've ordered a new switch, but I have no idea where the 4 wires go. I'm here to beg someone to look at theirs, and either snap a picture, or describe the layout, e.g. "red wire to left front, yellow wire to right front, etc."
I would very much appreciate some assistance. I need my truck-truck* back!
*After we (my wife, now, and I) bought it, we heard the owner's wife call out, somewhat sadly as we drove off, "Goodbye, truck-truck!" The name stuck.
-
This is from my Painless wiring manual - VERY similar:
(http://i123.photobucket.com/albums/o317/jjsabol/Scan5.jpg)
Follow the instructions under10.6.1 - ignore my notes.
Lousy scan.
Note 10.6.1 says NOTE: On late-style GM headlight switches, the park lights terminal to which wire 927 (brn) is connected (shown in Figure 10-6) has been omitted. In this case, wire 927 must be connected as indicated by the dash line in Figure 10-6.
-
Thanks for the reply. I forgot to mention that my truck is past inspection, so this is a pretty critical fix (a man is crippled without his truck, you know). I think I can follow your scan; please correct me if I am wrong: From left to right, it reads
Black dome and int light return
Red Blk
Brn
Blu/Ylw 14 ga
Brn 16 ga
Brn
Grn 14 ga
-
Crap. My wires are white, green, yellow, orange, orange, and brown. No stripes, no red, no blue.
-
Ok according to my old stock switch that I cut the wires from it is:
White to 961 BLK
Red to 928 RED/BLK
Yellow to 907 BLU/YLW
green to 930 BRN
both orange to 959 ORN
brown to 929 BRN
That I know is correct.
(http://i123.photobucket.com/albums/o317/jjsabol/Picswitch.jpg)
This is better:
(http://i123.photobucket.com/albums/o317/jjsabol/IM001238.jpg)
-
Now THAT I can follow. I've traced it out on my old switch, and it seems to make sense. Thanks for your help. I'll try to get a picture of truck-truck on here to show my appreciation.
-
Did you go to an aftermarket switch?
-
Yes, since I am rewiring my truck with a Painless wiring harness, I am using a Painless headlight switch. That's why the wire colors don't exactly match up.
-
FWIW
Red- constant 12v
Green- dash lamps
Lt. Green- Rear running/park lamps
Tan- Front running/park lamps
White- interior lamp switch
Blue- to dimmer switch input