73-87chevytrucks.com
73-87 Chevy _ GMC Trucks => Engine/Drivetrain => Topic started by: ngarman123 on November 17, 2008, 11:15:33 am
-
what gap do you guys set your plugs at? not really sure what year my engine is out of and not sure what gap to set my plugs at? thanks
-
Small block to big block, carb to TBI all makes a difference, and it is best for one to know all the correct info, or your truck will run like crap....
-
Type of ignition would help also.
-
Can you just pull a plug and call Autozone with the plug number?
-
what gap do you guys set your plugs at?
Since you are asking what gap "I" set mine at, versus what should "you" set your gap at, I set mine at .035 for my 5.7 engines
-
sorry guys i wasnt thinking and i didnt give you crap to go off of. ok its a 73-75?? frame with a small block 350 .030 over. stock heads performer intake and a 600cfm edelbrock carb. i am pretty sure it came with points but some one at some point switched it over to electronic ignition. i looked in my repair manual and i have alot of different choices from year to year for gap setting. i put plugs in it but am second guessing if i have the right ones in. i bought plugs for an 81 cause thats what the cab is. also it runs like crap untill it gets warm. thats kind of why i just got to thinking about it. thanks
-
What # plug did you put in? R44T?
-
You should get plugs that are right for the engine, not the truck cab. A truck might have a different engine than original equipment, so the plug to use may be entirely different. I use a plug in my 87 tbi that's an R43T gapped at .035" .My engine is not built up for performance. You can safely go up a heat range- to R44T, as Vile says, but be cautious not to go so high in heat range that you damage your pistons and blow a hole in the tops of em..
You can do a search for engine identification and find some info on where to look for your engine's id.