Author Topic: Factory Exhaust Manifolds  (Read 618 times)

Offline Jon87V20

  • Registered Users
  • *
  • Posts: 167
Factory Exhaust Manifolds
« on: January 27, 2018, 03:47:00 PM »
Im trying to replace my factory exhaust manifolds and found some used ones off of an 85 K-5 (thats all the info available). Im assuming if its a small block, they should bolt right up to my 87 Suburban V20, correct?

Also, any advice on getting the manifold bolts out without breaking them? Theyre looking intensely rusted.

Thank you, guys.
1987 Chevrolet Suburban V20 Silverado
350ci TBI TH400 NP208

Offline VileZambonie

  • Global Moderator
  • Senior Member
  • *****
  • Posts: 17252
Re: Factory Exhaust Manifolds
« Reply #1 on: January 27, 2018, 05:18:27 PM »
They are different manifolds. I would recommend getting new manifolds. They come with studs, gaskets etc.

,                           ___ 
                         /  _ _ _\_
              ⌠'   [☼===☼]
              `()_);-;()_)--o--)_)

Offline Jon87V20

  • Registered Users
  • *
  • Posts: 167
Re: Factory Exhaust Manifolds
« Reply #2 on: January 28, 2018, 02:20:34 AM »
Ok sounds good. Thanks, Vile.
1987 Chevrolet Suburban V20 Silverado
350ci TBI TH400 NP208