well its been a while since i have worked on my muder. last time i was ready to test drive it but the clutch didnt seem right. I tried starting it up Saturday and nothing happened, i checked and cleaned the connections and still nothing. pulled the starter and that works great. the tranny turns freely in nutrual (muncie 4 speed). checked the motor to see if its locked up but not sure. i went to spin it over and found the harmonic balancer bolt loss so i tightened that and didnt dare to wrench on it anymore in fear of snaping the head.
With that all said, where do i begin again to figure out the problem with the truck. The clutch is a 18 months old and never removed, the clutch fork is set properly as far as i can tell as well as the throw out bearing. which brings me to an other question. in chevyduty they show 2 throw out bearing one for 73-75 which is 1 7/8 in tall and another for 73-84 that is 1 1/4 tall would this make the difference if i had the taller bearing? i think that covers it, if i cant figure it out soon, i'm going to drop in a th350 instead
1
