Blazer rear quarter repair panel

[Laderhosen]

Does anyone know if Sherman part 923-60L which is listed as 'QTR PNL RR SEC LH/RH SUBURB 73-91' will work on a Blazer. I'm most concerned about the angle of the bottom edge. Is it the same on a Suburban as on a Blazer???

I can't find any listed on their website specifically for Blazers....

http://shermanparts.com/ecat/base/dropdowns.php?last0=CHEV&last1=BLFS&make=CHEV&model=BLFS&year=1987

Sherman and   parts are the only ones I can easily get hold of.

[topp]

Right above it is the blazer/Jimmy listed as QTR PNL FT SEC LH 73-91 BLZ/JI

[Laderhosen]

That's for the section that goes in front of the wheelarch though...??

[topp]

Part # 898-53BL

Is that not the same part, just for the Blazer/Jimmy?

[Laderhosen]

Part # 898-53BL

Is that not the same part, just for the Blazer/Jimmy?

No, click on the little blue square to the left of the part description and it shows a photo.....

[HAULIN IT]

All of those patch panels are listed as: Truck, Blazer & Suburban. You are correct, the bottom angle will be slightly steeper for the short bed truck, Blazer, ect., compared to the long bed & Suburban, however it should not be a problem...it will just "roll under" & you can cut it off flush with the existing portion of the panel. Lorne

[topp]

The one I am talking about does not have a little blue square next to it...

[Laderhosen]

All of those patch panels are listed as: Truck, Blazer & Suburban. You are correct, the bottom angle will be slightly steeper for the short bed truck, Blazer, ect., compared to the long bed & Suburban, however it should not be a problem...it will just "roll under" & you can cut it off flush with the existing portion of the panel. Lorne

Cool, but surely if I "roll under" the metal it'll make the angle even shallower?? Guess I'll have to roll it out and hopefully there'll be enough sheet metal....