« previous next »
Pages: [1]   Go Down

Author Topic: back glass rubber  (Read 3802 times)

Offline screamin86

  • Junior Member
  • ***
  • Posts: 661
back glass rubber
« on: November 21, 2009, 01:09:53 pm »
So im swaping out my slider for a soild back glass. My question is are the seals the same between the windows? Mine looks to have been replaced and is in great shape and if i dont have to have the down time waiting on a new seal that would be great. Any and all fast replys are welcome! Thanks guys and gals.
Logged
86 k10 lwb 4x4:350 .040 214/224 444/466 112lsa performer rpm 1406 lt's summit racing th350 2800stall
03 yukon xl:tint debadge full boltons
86 ta:lm7 hot cam boltons

Offline Irish_Alley

  • Tim
  • Senior Member
  • ****
  • Posts: 13333
  • Family is not an important thing. It's everything.
Re: back glass rubber
« Reply #1 on: November 22, 2009, 01:13:06 am »
the size of the window its self is the same but the style of the seal are diffrent in some years but it they will swap out
Logged
If you can’t tell yourself the truth, who can you tell it to?~Irish_Alley

When you have eliminated the impossible, whatever remains, however improbable, must be the truth ~Sherlock Holmes

Offline Captkaos

  • OWNER and Administrator
  • Administrator
  • Senior Member
  • *****
  • Posts: 18460
    • http://www.73-87chevytrucks.com
Re: back glass rubber
« Reply #2 on: November 22, 2009, 11:46:37 am »
I found that GM sliders use the same size gasket.  Aftermarket ones do not.
Logged

Offline screamin86

  • Junior Member
  • ***
  • Posts: 661
Re: back glass rubber
« Reply #3 on: November 22, 2009, 10:10:35 pm »
Im not 100% sure but mine looks to be original but its tinted and i believe my rpo code sheet says slider but not completely sure. Was maily wondering cause the seal looks awful wide in the channel where the slider is.
Logged
86 k10 lwb 4x4:350 .040 214/224 444/466 112lsa performer rpm 1406 lt's summit racing th350 2800stall
03 yukon xl:tint debadge full boltons
86 ta:lm7 hot cam boltons

Offline 1980c10

  • Senior Member
  • ****
  • Posts: 1205
Re: back glass rubber
« Reply #4 on: November 23, 2009, 04:31:39 am »
i would def. go with a new gasket. the slider is going to be wider where the glass slides. you also might get some wind noise and water leaking. a new gasket might also make it easier to install
Logged

Offline SUX2BU99

  • Senior Member
  • ****
  • Posts: 1478
    • My Cardomain Site. Truck is on Page 6.
Re: back glass rubber
« Reply #5 on: November 30, 2009, 10:41:56 am »
I had mine swapped out just 2 months ago from a slider to a solid I got from a regular glass shop. New one went in with the old seal no problems. I had the glass guy do it and he didn't have any problems either.
Logged
85 Chevy Silverado C10 short, wide, yellow, 2wd. Lowered, 60-over 350 with Dart Iron Eagle heads and Comp Cams XE268 cam, TH350 w/ shift kit, 3.40 Gov-lok 12 bolt.
Pages: [1]   Go Up
« previous next »