« previous next »
Pages: [1]   Go Down

Author Topic: Removing the front fenders skin  (Read 2444 times)

Offline scotttick

  • Newbie
  • Posts: 7
  • Young Bull
Removing the front fenders skin
« on: April 14, 2013, 02:28:53 am »
Is there any way to remove the skin off a front fender?  If so, how difficult is it to remove and get back on.  I have a crease in the front corner where I cannot get to the backside.  If anyone has a better way to remove the crease I would like to here it too.  Thanks
Logged

Offline Macj1983

  • Registered Users
  • *
  • Posts: 120
  • Newbie
Removing the front fenders skin
« Reply #1 on: April 14, 2013, 09:53:40 am »
It's really not that bad just to unbolt the whole thing just a little time nothing to complex though
Logged

Offline theaddictedchef

  • Newbie
  • Posts: 96
  • Newbie
Re: Removing the front fenders skin
« Reply #2 on: April 14, 2013, 10:48:35 am »
I JUST did this to replace the blower motor.   It isn't hard at all and if u remember correctly, it's 12-14 bolts that go along the skirt and the inner well.   I sprayed them down with some lithium prior so I wasn't fighting dirt and rust, but all in all, not bad.   

Sent from my SCH-I535 using Tapatalk 2

Logged
The Journey IS the Reward......
Pages: [1]   Go Up
« previous next »