How low would/did you go?

[Blue Diamond24]

86 shortbed btw, I think im goin to do a 5/7 eventually when I get the funds

Results (total votes = 18):

2/4	6 / 33.3%
3/5	4 / 22.2%
4/6	4 / 22.2%
5/7	4 / 22.2%

         -~Blue Diamond~-
         -~A Faction Bum~-

[1976Scottsdale]

I vote 3/5.  You want to keep the body off the deck on bumpy roads.

[OLDRED]

Long bed 4/6 short bed 5/7  

[1bad86c10]

2/4, i just installed a sweet set of long tubes and my 4/6 drop lets them drag so now i have to raise it back to 2/4 so it all depends on what you have hanging under the truck.

[Sano]

I'm pro low rider soooooooooooo, I'd say 6/7 or 6/8 just to give it a little rake. Theres quite a few combinations that you can do to get them low....and unless your roads are filled with potholes and stuff I'd have it hugging the ground

[toplessblazer]

I agree with sano... If it aint sparkin, park it.

[77c15]

My 74 longbed is getting the Summit 3/4 drop this weekend. I'll get pix and post this weekend.
-Mike

[Blue Diamond24]

i live out in the country so i cant go tooo low...

my next project vehicle is goin to be an 86 4 door, longbed 1ton thats going to sit on the ground with air, again, when i get the funds

-Verdex
-A Faction Bum
-Xenos-
-Blue Diamond
-Atraxerxes
-Brian

[85chevykid]

how low did i go i had a 4/6 on my 85 c-10 long box but then i took it all off and bagged it...

[Pushrod]

Dropped my rusty junk 5/5 and lookin to go lower.

[Copper Canyon]

Well it all depends on the look your goin for and what size rim your runnin'.  My '86 short box is on 17" Torq thrust II 255/60 size tires, and it's goin to get lowered 2" on all 4 corners.  

The 81-87 C-10 is a fairly level truck (rear end is about 1/4" higher than the front end).  My taste is to keep the truck classic but with a modern twist.  Plus a 2" drop all around only costs about $185, and you don't need to buy shocks.

[shaved80]

to the doors! but that's just me  

[lowc10]

6/6 for a rake, but long tubes will be real close to the ground. I'm at 3/6 and need to put my 3" spindles on to get the 6/6. I will get to it one day.

[WELD4DAYS]

Go low.Go with bags and go as high or low as you want.I like shaved80, comment to the doors..

[Copper Canyon]

Just put on my 2/2 kit.  Heres what she looks like.

Edited by: Copper Canyon at: 12/28/06 5:41 pm