New parts ordered!

[76k104x4]

After getting my new headers installed the factory plug wires touch the header tubes on my 454. Also I figured it's about time to replace the distributor too so I ordered a distributor, HEI corrected cap, jegs 8.5 cut to fit wires with multi angle boots, plug wire boot heat shields, Moroso wire looms, and a Moroso recurve kit. I can't wait for parts to start showing up. Any suggestions about install?

[bake74]

     If you are talking distributor, find TDC, make sure your rotor is pointed at #1 cylinder and remove, re-install as you removed.

[76k104x4]

Thanks Bake. Does anyone have any experience with putting in the recurve kit or suggestions on it?

[swilliams]

This is one thing I have read Truck not running right after a recurve kit.

[76k104x4]

The link isn't working.

[bd]

@ 76k104x4 - try the link now.

@ swilliams - take a new look at your post to see how the "Hyperlink" code is used.   

[swilliams]

Sorry about the messed up link.
Thanks for the correction bd

[76k104x4]

No problem thanks guys. Y'all make this a great site.