« previous next »
Pages: [1]   Go Down

Author Topic: Wiper Hi Speed Intermitten Operation  (Read 2916 times)

Offline kuhnzoo

  • Newbie
  • Posts: 9
  • Newbie
Wiper Hi Speed Intermitten Operation
« on: June 18, 2015, 07:34:19 pm »
85 K10, 305, 700R4. Wipers work on low setting, but stop (where ever they are) when placed on Hi setting. However, if I cycle the high beam switch the wipers will then work on the Hi settings. Strange, huh? Anyone have any ideas or similar experience?

These are standard off/lo/hi wipers - no delay feature.

Thanks!

Rob
Logged
1985 K10 350CID A/T

Offline Irish_Alley

  • Tim
  • Senior Member
  • ****
  • Posts: 13333
  • Family is not an important thing. It's everything.
Re: Wiper Hi Speed Intermitten Operation
« Reply #1 on: June 19, 2015, 07:54:30 am »
im going to say poor contact in the switch itself. and when you cycle high beams it gives it enough contact to start it. this is a 100% guess and i cant even tell you how to test it
Logged
If you can’t tell yourself the truth, who can you tell it to?~Irish_Alley

When you have eliminated the impossible, whatever remains, however improbable, must be the truth ~Sherlock Holmes

Offline kuhnzoo

  • Newbie
  • Posts: 9
  • Newbie
Re: Wiper Hi Speed Intermitten Operation
« Reply #2 on: June 19, 2015, 08:21:46 am »
Yeah, I was leaning toward the switch as you mention. Could not see anything obvious on wiring schematic that looked like the hi speed wiper circuit was inter-related to the high beam circuit.

Only thing they seem to share is a common integration in stalk.

Thanks,

Rob

Sent from my MB520 using Tapatalk 2

Logged
1985 K10 350CID A/T
Pages: [1]   Go Up
« previous next »