« previous next »
Pages: [1]   Go Down

Author Topic: 700R transmission  (Read 2434 times)

Offline 85ChevyRyder

  • New Users
  • Posts: 1
  • Newbie
700R transmission
« on: February 19, 2016, 04:23:48 pm »
Hello all! I have a 700R transmission with a 2800 stall that's having trouble getting into gear. I started it, backed it out the garage,  then back in. Waited a few minutes, started the truck again and now it will not get in gear. Transmission is full of fluid and not leaking. Any ideas on why it won't go into gear?

Thanks!
Logged

Offline Fairlane514

  • Frequent Member
  • **
  • Posts: 493
  • Newbie
Re: 700R transmission
« Reply #1 on: February 19, 2016, 07:13:33 pm »
Is it a fresh rebuild?   Possible the linkage disconnected from the manual valve.
Logged

Offline bd

  • Global Moderator
  • Senior Member
  • *****
  • Posts: 6600
Re: 700R transmission
« Reply #2 on: February 19, 2016, 07:29:30 pm »
...or the link between the column and transmission is loose or separated?
Logged
Rich
It's difficult to know just how much you don't know until you know it.
In other words... if people learn by making mistakes, by now I should know just about everything!!!
87 R10 Silverado Fleetside 355 MPFI 700R4 3.42 Locker (aka Rusty, aka Mater)

Offline jg1977c20

  • Registered Users
  • *
  • Posts: 104
  • Newbie
Re: 700R transmission
« Reply #3 on: February 23, 2016, 02:47:15 am »
take the pressure line off at the cooler and get a bucket to catch the fluid -have a buddy start it up and see if you get good pressure - other than that the forward clutches are likely gone if has some miles on it
Logged
1977 c20 cheyenne camper special 8200gvw
Pages: [1]   Go Up
« previous next »