« previous next »
Pages: [1]   Go Down

Author Topic: tranny question  (Read 4299 times)

Offline 85silverado

  • Newbie
  • Posts: 62
tranny question
« on: February 24, 2006, 12:30:00 am »
I posted in drivetrains but no luck. Does anyone know the procedures of replacing the seal in the shift shaft on a 700R4?

Logged

Offline 123 pugsy

  • Junior Member
  • ***
  • Posts: 925
Re;Tranny
« Reply #1 on: February 24, 2006, 12:36:00 pm »
It appears as though none of us has had this problem.:|  

Logged
Pugsy
76 C10 LWB
TPI 350

Offline 85silverado

  • Newbie
  • Posts: 62
tranny question
« Reply #2 on: February 24, 2006, 01:37:00 pm »
I don't know why no one else has had this problem, I have seen it at the dealership many times, just never have fixed one.

Logged

Offline VileZambonie

  • Global Moderator
  • Senior Member
  • *****
  • Posts: 19210
Shift Shaft seal
« Reply #3 on: February 24, 2006, 03:32:00 pm »
It's easy. I have the tool to do it but you really don't even need the remover installer to do it. Remove the shift linkage and pry the old seal out using a small screwdriver or cotter pin tool and drive the new one in with a socket. Make sure you lube the new seal with either vaseline or atf.  

Logged
,                           ___ 
                         /  _ _ _\_
              ⌠ŻŻŻŻŻ'   [☼===☼]
              `()_);-;()_)--o--)_)

74 GMC, 75 K5, 84 GMC, 85 K20, 86 k20, 79 K10

Offline 85silverado

  • Newbie
  • Posts: 62
tranny question
« Reply #4 on: February 25, 2006, 02:58:00 am »
Thanks for the advice. I knew there couldn't be much to it, just didn't want to screw anyhthing up.

Logged
Pages: [1]   Go Up
« previous next »