Author Topic: Front shock movement  (Read 151 times)

Offline 502Silverado

  • Newbie
  • Posts: 4
  • Newbie
Front shock movement
« on: September 18, 2018, 06:19:12 PM »
Hey all, I have an 87 R10 I bought in June.  Notice the front end has a creak to it and noticed that when I push down on the driverís side of the truck the upper mount is loose and moves independently of the frame.  Anyone know what could cause this?  Iím hoping that the hole in the frame isnít elongated where the stud goes through. Ive bought new shocks to install but donít want to take that side off in case it needs repairing. Also, if the hole IS elongated, how is that fixed?  Any help is appreciated. This is my first C10 and Iím learning as I go. Thanks

Offline square81

  • Registered Users
  • *
  • Posts: 110
Re: Front shock movement
« Reply #1 on: September 25, 2018, 10:03:10 PM »
Ive replaced my shocks due to wear. While at it i put shock brackets from offroad design on. Gives it a double shear point and helps with mounting hole wear.

Offline VileZambonie

  • Global Moderator
  • Senior Member
  • *****
  • Posts: 16999
Re: Front shock movement
« Reply #2 on: September 26, 2018, 04:40:50 AM »
Check to see if it is just loose. If it's egged out you can repair it.
,                           ___ 
                         /  _ _ _\_
              ⌠ĮĮĮĮĮ'   [☼===☼]
              `()_);-;()_)--o--)_)

Offline 502Silverado

  • Newbie
  • Posts: 4
  • Newbie
Re: Front shock movement
« Reply #3 on: October 13, 2018, 08:44:30 PM »
Thanks for the responses. I planned on getting the shock mount braces just to be on the safe side. Itís a 2wd so no off road stresses on the suspension.