Author Topic: u joint question  (Read 369 times)

Offline jcondo

  • Newbie
  • Posts: 18
  • Newbie
u joint question
« on: October 08, 2018, 06:54:04 PM »
Did they use 2 different u joints on the front axle in 77 K10?
passenger side went together just fine with a 371 u joint, but the driver side wont go flush and wont slide into the hub casing if they are not flush.
Thanks for any info.

Offline Captkaos

  • OWNER and Administrator
  • Administrator
  • Senior Member
  • *****
  • Posts: 18118
    • http://www.73-87chevytrucks.com
Re: u joint question
« Reply #1 on: October 10, 2018, 10:45:07 PM »
Are we talking the inner to outer shafts U-joints.  They "should" match.

Offline JohnnyPopper

  • Frequent Member
  • **
  • Posts: 252
  • Newbie
Re: u joint question
« Reply #2 on: December 25, 2018, 06:06:50 PM »
They were the same on my '78.

Check the build date; was it on a Friday after 3pm? Those '70's were wild! :>)