« previous next »
Pages: 1 [2]   Go Down

Author Topic: Replacing rack sector for a tilt steering column  (Read 13250 times)

Offline JohnnyPopper

  • Senior Member
  • ****
  • Posts: 2734
  • Old Goof
Re: Replacing rack sector for a tilt steering column
« Reply #15 on: January 04, 2025, 07:31:00 pm »
VZ you DO have a sense of humor!

That evoked quite a belly laugh! TY!!

At my age, I hope to never have to use a lockplate depressor. Though you never know, right?

I'll take your advice about the creepers. They would have relieved so much pain...

When not used, I will store them next to my muffler bearing grease gun... 8)
Logged
1957 Apache 3100 235 Inline 6, 3 on the tree
1973 C-20, 3+3 454 4BBL TH400  Water Injection
1978 K-10, 350 4BBL TH350 NP203 M.M. Part time Kit/Hubs
1980 C-10 under construction

Online bd

  • Global Moderator
  • Senior Member
  • *****
  • Posts: 6610
Re: Replacing rack sector for a tilt steering column
« Reply #16 on: January 04, 2025, 08:35:00 pm »
Quote from: JohnnyPopper on January 04, 2025, 07:31:00 pm
...I will store them next to my muffler bearing grease gun... 8)

If you actually have one of those you should hold onto it.  I understand they are pretty rare and worth quite a bit.
Logged
Rich
It's difficult to know just how much you don't know until you know it.
In other words... if people learn by making mistakes, by now I should know just about everything!!!
87 R10 Silverado Fleetside 355 MPFI 700R4 3.42 Locker (aka Rusty, aka Mater)
Pages: 1 [2]   Go Up
« previous next »