I purchased 2.5 drop spindle's for my 87 Silverado r10 long bed.
Everything went according to plan except that the center hub bolt on the spindle was little short not even a quarter of an inch,.
I had to drill a new hole for the cotter pin and the wheel still spins free hand with no problem, when I dropped the truck and rolled it I heard a grinding noise, so I took the wheel off and in the back the weight was grinding on something, so I grinded the lower control arm a little and purchased a 5 /16 wheel spacers, if I go in reverse there is no noise, if I go forward its not so bad but I hear rubbing on both wheels.
Any help would be appreciated, tired of taking these dag on wheels in and out, my back is killing me .
This truck is my heart
Thanks in advance