73-87chevytrucks.com
73-87 Chevy _ GMC Trucks => Engine/Drivetrain => Topic started by: 87454westernhauler on October 03, 2011, 08:25:58 pm
-
I have an 87 R10 chevy 305, 4speed with a posi in the rear that I bought off of my dad that I have bean trying to get runing and went to take it for a test drive and found out that a coon or something chewed a hole in the flex/ braded metal gas lines that run up the back of the motor next to the trans up to the throdle body. my local parts stores do not have them.I probably can get one from a junk yard, buti would prefer new ones.
-
You have 2 options that I know of... New ones from the dealer or have some made from a hose place.
-
I found a set by googling the OEM #'s but I also made a set. If you go to a decent autoparts store they should have fuel injection line repair hose and fittings.
-
I got a used set of them for 10 bucks, but now it is all jumpy and spazes when you accel.
-
I got a used set of them for 10 bucks, but now it is all jumpy and spazes when you accel.
Are you sure you have them sealed and they are not sucking in air ?
-
i believe i do cause if i didn't it would be leaking gas every where because of the fuel pump being in the tank, I am wondering if the o2 sensor is bad?
-
check your codes. even with the cel off a code can still be stored
-
think that i figured out why it is surging, found out that the o2 sednsor is snaper off. just scored two runing and drivable trucks for 900 bucks, an 85 c20 custom with a new rebuilt 350 and an 89 gmc 1500 and just sold my rusted out old 80 c10 for 1500. ;D