« previous next »
Pages: [1]   Go Down

Author Topic: Hood hanging  (Read 4078 times)

Offline TandocTools

  • Newbie
  • Posts: 47
Hood hanging
« on: January 22, 2011, 04:18:15 pm »
I can't seem to adjust my new hood--when its low enough in the back the front side is misalligned.  This is the best I can do:  My fenders have a bunch of shims on the passenger side and I suspect that my hood opening is not very square.  Any tips?
Thanks,
WT
Logged

Offline txchainsawgogi

  • Junior Member
  • ***
  • Posts: 584
Re: Hood hanging
« Reply #1 on: January 22, 2011, 04:52:12 pm »
Dang diggin that truck. Do you think maybe the hood manufacturer fugged up on yours?
Logged

Offline thirsty

  • Senior Member
  • ****
  • Posts: 1289
    • Suitor's Garage
Re: Hood hanging
« Reply #2 on: January 22, 2011, 05:08:11 pm »
There is a post on here about adjusting hoods that I remember seeing. I bet if you can get that back down it will fit.
Logged
Real trucks are built, not bought Build thread

Give me a long enough lever and a place to stand, and I shall move the earth or break this bolt...Whatever, just hold my beer!

Offline 1980c10

  • Senior Member
  • ****
  • Posts: 1205
Re: Hood hanging
« Reply #3 on: January 22, 2011, 11:46:49 pm »
Have you replaced the fenders? I had some serious problems with aftermarket fenders not allowing the hood to close properly. It was hitting near the header panel. also you could remove the hinges and see if lays in correctly.
Logged

Offline TandocTools

  • Newbie
  • Posts: 47
Re: Hood hanging
« Reply #4 on: January 23, 2011, 11:57:51 am »
I read the post and tried again--Still not perfect, but much better!  Thanks everyone!
Logged

Offline jackjeckel757

  • Registered Users
  • *
  • Posts: 102
Re: Hood hanging
« Reply #5 on: January 23, 2011, 02:32:48 pm »
yep mine does the same thing, I blame my newer aftermarket fenders...
Logged
Pages: [1]   Go Up
« previous next »