Thanks everyone... it has been sitting for almost two years so while the ball is rolling I can't seem to stop myself. I built the bracket for the back to flip it over. I used a piece of 3/8 steel and used a cutting wheel to cut it to the correct width. Then, I heated up the metal and bent it over on a straight line over another piece of metal twice to make the half square. I lined them up drilled the hole for the leaf spring bolt and then cut the excess off to make them even. I had enough metal to try 6 times to make 2, lucky I got all the bends in the right spot the first time. I'd like to take credit for building something in the front but I just cut the springs to level it out. I started out with just one coil but ended up doing one and a half. It ended up being a 5/3 drop and I am very pleased with the height. If I wasn't going with an air suspension eventually then this is where my truck would ride forever.... gotta go back to work... later
1
