« previous next »
Pages: 1 [2]   Go Down

Author Topic: info on engine  (Read 14070 times)

Offline Fairlane514

  • Frequent Member
  • **
  • Posts: 493
  • Newbie
Re: info on engine
« Reply #15 on: August 08, 2012, 11:06:01 pm »
If you are new to this stuff, then you do need to do as Captkaos suggested and go to a reputable machine shop and get some advice.

It may not need boring, you need to match heads, cam, intake etc., for what you are trying to achieve.
Logged

Offline Farm boy

  • Newbie
  • Posts: 99
  • Newbie
Re: info on engine
« Reply #16 on: August 12, 2012, 05:44:26 pm »
Yah i need to find a good machine shop. It does need to be bored though; there is a light lip at the top of the cylinder travel. As for the rpm capability i know i can't have both i more meant be able to handle the higher rpm without failure (though high rpm is relative here).

But yah i really need to start looking for a good machine shop:)
Logged
K10-350 w/Holley 4bl, 350th, 33-12.5-15s, blue)-parting out
K10-350 w/Holly 4bl, bad th350 swapping to sm465, 33-12.5-15s, CAMO!
Pages: 1 [2]   Go Up
« previous next »