« previous next »
Pages: [1]   Go Down

Author Topic: Wood Bed  (Read 2807 times)

Offline Zeked

  • Newbie
  • Posts: 71
Wood Bed
« on: September 26, 2012, 04:18:21 pm »
My 87 Short Step bed has been revaged by the dreaded rot monster,  I have new white oak and stainless parts to fix it, but the washers for the bed tie downs baffle me.  Why are they eccentric?  Is there any reason not to use centered washers?  As a wingman used to say "WTH -Over"?

Zeke
Logged
Often Wrong......Never in Doubt!

Offline Zeked

  • Newbie
  • Posts: 71
Re: Wood Bed
« Reply #1 on: September 28, 2012, 09:05:42 pm »
OK
  there isnt any good reason.     the off center hole lines up in line with the eccentricity.......it goes fore/aft so it does not put the washer in the middle of the board, over the braces, or near anything that makes sense.   Did GM get these washers for free?   People wanna know.....
Logged
Often Wrong......Never in Doubt!

Offline Captkaos

  • OWNER and Administrator
  • Administrator
  • Senior Member
  • *****
  • Posts: 18466
    • http://www.73-87chevytrucks.com
Re: Wood Bed
« Reply #2 on: October 15, 2012, 12:49:46 pm »
I believe it was to make the washer in the center of the board, and to keep the normal Fleetside mounting location.
Logged

Offline Big Katz

  • Newbie
  • Posts: 60
Re: Wood Bed
« Reply #3 on: October 16, 2012, 12:47:48 pm »
I was wondering the same thing about the washers. I just figured the offset washer recessed in the wood was more of a anti rotation for the carriage bolt.
Logged
Pages: [1]   Go Up
« previous next »