« previous next »
Pages: [1]   Go Down

Author Topic: 1"-2" body lift  (Read 3305 times)

Offline Mph306

  • Newbie
  • Posts: 5
  • Newbie
1"-2" body lift
« on: May 24, 2014, 11:20:26 am »
Hey guys. Does 1"-2" body lift require anything but the lifting blocks? Like lineages and what not. Also is fan shroud have to be trimmed for a small body lift?
Logged

Offline Mph306

  • Newbie
  • Posts: 5
  • Newbie
Re: 1"-2" body lift
« Reply #1 on: May 24, 2014, 11:47:55 am »
I have an 86 rclb 305 4x4 4spd
Logged

Offline Irish_Alley

  • Tim
  • Senior Member
  • ****
  • Posts: 13333
  • Family is not an important thing. It's everything.
Re: 1"-2" body lift
« Reply #2 on: May 24, 2014, 10:51:22 pm »
fan should have to be trimmed. the only thing i can think of is the steering intermediate shaft, you have to pull it apart sometimes can be done easy others might have some rust holding her up.
Logged
If you can’t tell yourself the truth, who can you tell it to?~Irish_Alley

When you have eliminated the impossible, whatever remains, however improbable, must be the truth ~Sherlock Holmes

Offline bake74

  • Senior Member
  • ****
  • Posts: 5871
    • Build Thread
Re: 1"-2" body lift
« Reply #3 on: May 24, 2014, 11:45:38 pm »
     Some people lower the fan shroud to match.
Logged
#1: The easiest and most obvious solution to any problem is 99% of the time correct.
#2: There is no such thing as impossible, it just takes longer.
  74 k10, 77k10    Tom

Offline Captkaos

  • OWNER and Administrator
  • Administrator
  • Senior Member
  • *****
  • Posts: 18462
    • http://www.73-87chevytrucks.com
Re: 1"-2" body lift
« Reply #4 on: May 25, 2014, 11:35:48 am »
Clutch linkage will need to be lengthened unless it is hydraulic still.
Logged
Pages: [1]   Go Up
« previous next »