« previous next »
Pages: [1]   Go Down

Author Topic: Aluminum bezel 2 5/8 guages question  (Read 2912 times)

Offline hobbz

  • Registered Users
  • *
  • Posts: 116
Aluminum bezel 2 5/8 guages question
« on: September 05, 2014, 12:44:18 pm »
I ordered the aluminum bezel and am going to do the 2 5/8 gauges flush mounted in it. 

How much do I have to expand the holes in the aluminum?  Just looking for an estimate.  I don't have the bezel or gauges yet to measure.
Logged
1987 Chevy R10 Short/Step -  350/th350
Build Thread

Offline hobbz

  • Registered Users
  • *
  • Posts: 116
Re: Aluminum bezel 2 5/8 guages question
« Reply #1 on: September 06, 2014, 12:11:00 pm »
anyone???
Logged
1987 Chevy R10 Short/Step -  350/th350
Build Thread

Offline Stewart G Griffin

  • Senior Member
  • ****
  • Posts: 3324
Re: Aluminum bezel 2 5/8 guages question
« Reply #2 on: September 06, 2014, 01:49:35 pm »
What aluminum bezel?
Logged

Offline hobbz

  • Registered Users
  • *
  • Posts: 116
Re: Aluminum bezel 2 5/8 guages question
« Reply #3 on: September 06, 2014, 03:12:30 pm »
Like the one Chris sells on the store here.  The holes are about 2 1/2"
Logged
1987 Chevy R10 Short/Step -  350/th350
Build Thread

Offline Captkaos

  • OWNER and Administrator
  • Administrator
  • Senior Member
  • *****
  • Posts: 18461
    • http://www.73-87chevytrucks.com
Re: Aluminum bezel 2 5/8 guages question
« Reply #4 on: September 06, 2014, 03:35:43 pm »
How much you need to do depends on the size of the gauges you plan to mount..
http://73-87.com/7387garage/interior/gauge_surface.htm
Logged
Pages: [1]   Go Up
« previous next »