« previous next »
Pages: [1]   Go Down

Author Topic: Ladder Bar  (Read 4001 times)

Offline Irish_Alley

  • Tim
  • Senior Member
  • ****
  • Posts: 13333
  • Family is not an important thing. It's everything.
Ladder Bar
« on: November 15, 2009, 02:05:35 am »
well after putting on the new 6" lift, i have more axle rap that before. i know its the wedges they have round edges for some reason so I'm going to fix that and also build some ladder bars and hints or tricks to help me out. also are ladder bars similar to traction bars?
Logged
If you can’t tell yourself the truth, who can you tell it to?~Irish_Alley

When you have eliminated the impossible, whatever remains, however improbable, must be the truth ~Sherlock Holmes

Offline Chevalade

  • Frequent Member
  • **
  • Posts: 329
Re: Ladder Bar
« Reply #1 on: November 15, 2009, 09:38:59 am »
Yup...same thing. Before spendin bucks on bars, you could try clamping the front of the spring pack. if that don't work, then maybe build the bars. Try to make them as lond as the rear driveshaft. This helps avoid potential binding as the suspension cycles.
Logged

Offline joesgarage71

  • Wrench
  • Senior Member
  • ****
  • Posts: 1156
Re: Ladder Bar
« Reply #2 on: November 16, 2009, 04:09:30 pm »
Cal tec bars would be good or build some just like them.
Logged
78' K-20 355/SM465/twin stick 205 6" on 36's
14 bolt FF/big bearing Dana 44 4.56 gears
92' GMC C-1500 454/4L80E/14 bolt

Offline fitz

  • Senior Member
  • ****
  • Posts: 2086
Re: Ladder Bar
« Reply #3 on: November 20, 2009, 05:47:42 pm »
I can get you the measurements off of mine if you are going to make them yourself.
Logged
Pages: [1]   Go Up
« previous next »