« previous next »
Pages: [1]   Go Down

Author Topic: Oh, what to do.....  (Read 4243 times)

Offline Low87c10

  • Newbie
  • Posts: 44
Oh, what to do.....
« on: May 02, 2011, 03:25:33 pm »
It's an 87 R10 short, 275/60/15s rear, 265/60/15s front. Going to drop it...not slam it. Anyone have any good ideas on how far to go and how to best go about it? The only thing that is out of the question is I will not cut the frame.
Logged

Offline bake74

  • Senior Member
  • ****
  • Posts: 5871
    • Build Thread
Re: Oh, what to do.....
« Reply #1 on: May 02, 2011, 05:30:13 pm »
     Are you looking to go as low as possible with the tire set up you have and without cutting the frame, or something like a 2" x 3" drop ?
Logged
#1: The easiest and most obvious solution to any problem is 99% of the time correct.
#2: There is no such thing as impossible, it just takes longer.
  74 k10, 77k10    Tom

Offline beastie_3

  • Senior Member
  • ****
  • Posts: 3170
  • Josh
    • My truck pics
Re: Oh, what to do.....
« Reply #2 on: May 02, 2011, 06:07:35 pm »
lowering the red truck? it looks lowered already. either way, how much farther do you want to go? 2/3 to a 3/5 sounds good. I google for pics to see what YOU like
Logged

Offline Low87c10

  • Newbie
  • Posts: 44
Re: Oh, what to do.....
« Reply #3 on: May 03, 2011, 06:37:53 am »
Will a 3/5 work without tire rub? Should I go spindles or springs? In the back...shackles? monoleaf? Looking to do it easy, but still keep a reasonably decent ride.
Logged

Offline beastie_3

  • Senior Member
  • ****
  • Posts: 3170
  • Josh
    • My truck pics
Re: Oh, what to do.....
« Reply #4 on: May 03, 2011, 03:58:13 pm »
only you can tell if it will rub or not. its easy to see if the fenders will rub if its lowered 3 inches in the front. remember to check it with wheels straight and then again with wheels turned, taking into account suspension travel from bumps and such.
Logged
Pages: [1]   Go Up
« previous next »