« previous next »
Pages: [1]   Go Down

Author Topic: Header question  (Read 2844 times)

Offline ToddN

  • Newbie
  • Posts: 93
Header question
« on: October 01, 2011, 07:20:53 AM »
Quick header question.  I have an 85 K10 4x4 with a 1990 5.7l 350.  When ordering new headers do I buy them for the 90' 350 or the 85' chassis?  Or does it even matter?
Logged
A government big enough to give you everything you need, is a government big enough to take everything you have.

Offline firefighter

  • Frequent Member
  • **
  • Posts: 462
Re: Header question
« Reply #1 on: October 01, 2011, 07:29:39 AM »
It may not make a difference in this situation, but order them for the chassis of the vehicle they are going in to. In other swaps, that can make a big difference.
Logged

Offline ToddN

  • Newbie
  • Posts: 93
Re: Header question
« Reply #2 on: October 01, 2011, 07:39:49 AM »
Gotcha.  Thankyou.
Logged
A government big enough to give you everything you need, is a government big enough to take everything you have.

Offline bake74

  • Senior Member
  • ****
  • Posts: 5871
    • Build Thread
Re: Header question
« Reply #3 on: October 01, 2011, 04:08:59 PM »
     You should be able to check with the manufacture to make sure they will bolt up to both heads before you order.  Otherwise you will get them and they wont fit on the heads.
Logged
#1: The easiest and most obvious solution to any problem is 99% of the time correct.
#2: There is no such thing as impossible, it just takes longer.
  74 k10, 77k10    Tom
Pages: [1]   Go Up
« previous next »