« previous next »
Pages: [1]   Go Down

Author Topic: Heater box bolts  (Read 4161 times)

Offline Senck243

  • Newbie
  • Posts: 95
Heater box bolts
« on: June 16, 2012, 06:24:27 pm »
Broke the heater box bolts that go through the firewall. They are special headless bolts with clips to prevent them from spinning. Does anyone know where I can pick some up?
Logged
1984 k10 305, sm465, np208

Offline frotosride

  • Senior Member
  • ****
  • Posts: 1428
    • WFO CONCEPTS
Re: Heater box bolts
« Reply #1 on: June 16, 2012, 07:23:07 pm »
They are not in the catalok here on this site but you could try seperating the bolts from the clips and get a stud with a square neck. the square neck will hold it in place enough to tighten them down.
Logged
"Beat it like a red-headed ford"
1987 v10 Silverado(LQ4), 87 R10,83 K20, 83 cucv 6.2 Detroit
2006 Boulevard M109R 109 cid,2019 M109R BOSS
2009 Jeep XK, (future LS Swap)
GSXR 750 engine awaiting go kart

Offline bake74

  • Senior Member
  • ****
  • Posts: 5871
    • Build Thread
Re: Heater box bolts
« Reply #2 on: June 17, 2012, 04:52:19 pm »
     If no one responds, e-mail the store on this site and Chris (kaptkoas) might have a source.  Have you tried any local parts stores or the Chevy dealership yet ?
Logged
#1: The easiest and most obvious solution to any problem is 99% of the time correct.
#2: There is no such thing as impossible, it just takes longer.
  74 k10, 77k10    Tom

Offline Captkaos

  • OWNER and Administrator
  • Administrator
  • Senior Member
  • *****
  • Posts: 18462
    • http://www.73-87chevytrucks.com
Re: Heater box bolts
« Reply #3 on: June 28, 2012, 04:11:08 pm »
In general, I don't sell bolts, you can get singles locally for less than the hassle it takes for me to stock them....
Logged

Offline Senck243

  • Newbie
  • Posts: 95
Heater box bolts
« Reply #4 on: June 30, 2012, 07:07:55 am »
Chevy dealer discontinued. Can't get anything from local parts stores. I have something I got put it's gonna take more messing with to make it work then I would like to do for a heater box, put that is the way this project has been going
Logged
1984 k10 305, sm465, np208

Offline timthescarrd

  • Frequent Member
  • **
  • Posts: 326
Re: Heater box bolts
« Reply #5 on: June 30, 2012, 09:51:29 am »
Junkyard?
Logged
Pages: [1]   Go Up
« previous next »