« previous next »
Pages: [1]   Go Down

Author Topic: Body Lift Bumper Bracket Fabrication  (Read 4111 times)

Offline Altoids94

  • Newbie
  • Posts: 4
  • Newbie
Body Lift Bumper Bracket Fabrication
« on: September 10, 2014, 05:32:51 pm »
Does anyone know if anyone fabs body lift bumper brackets and where I can buy them? I bought my 1980 shortbox and recently purchased a rear bumper to fit on it to be only disappointed that the 3" body lift that was previously installed makes a big ugly gap!  I have looked around for these brackets with no luck.  If not does someone have some pictures of there 3" body lift brackets so I can fab them up myself?  Thanks!
Logged
1980 K10
4" Skyjackers Softride Suspension Lift / 3" Body Lift / 35" BFG All Terrain / 14 Bolt FF / NP205 / SM465 / 350 SBC with bolt ons

Offline Blazin

  • Blazin new trails!
  • Senior Member
  • ****
  • Posts: 6130
Re: Body Lift Bumper Bracket Fabrication
« Reply #1 on: September 10, 2014, 06:39:55 pm »
Cut the bracket, weld in a 3" wide piece of steel, & weld the cut off piece to that.
Logged
Some people are like Slinkies. Not really good for anything, but they still bring a smile to your face when you push them down a flight of stairs

Offline bake74

  • Senior Member
  • ****
  • Posts: 5871
    • Build Thread
Re: Body Lift Bumper Bracket Fabrication
« Reply #2 on: September 10, 2014, 10:29:23 pm »
     I don't have any pics or the truck any more for that matter.  But all I did was what Blazin basically said.  I took off the brackets and made them so they sat 3" higher.
Logged
#1: The easiest and most obvious solution to any problem is 99% of the time correct.
#2: There is no such thing as impossible, it just takes longer.
  74 k10, 77k10    Tom
Pages: [1]   Go Up
« previous next »