« previous next »
Pages: [1]   Go Down

Author Topic: 86 C10 Fuse panel  (Read 15585 times)

Offline reelbrothers

  • New Users
  • Posts: 1
  • Newbie
86 C10 Fuse panel
« on: November 06, 2014, 02:11:00 PM »
Ok, was wiring a new Choke on Holly Carb, Dummy let the connector hit the Valve cover, yea I know.
Anyhow It was connected in the Far upper right position and of coarse blew a fuse, however I have pulled all of them and cant find the culprit (other than me) the After market voltage gauge was also connected directly below and not working, anyone know where to look?
Logged

Offline bd

  • Global Moderator
  • Senior Member
  • *****
  • Posts: 6462
Re: 86 C10 Fuse panel
« Reply #1 on: November 06, 2014, 02:39:05 PM »
On a 1986 CK, the two top-right cavities are protected by the Choke fuse, which receives its power directly from the ignition switch.  Go figure!   :o

If the fuse isn't melted or cracked, check the fusible links at the firewall junction block and starter B+.
Logged
Rich
It's difficult to know just how much you don't know until you know it.
In other words... if people learn by making mistakes, by now I should know just about everything!!!
87 R10 Silverado Fleetside 355 MPFI 700R4 3.42 Locker (aka Rusty, aka Mater)

Offline Irish_Alley

  • Tim
  • Global Moderator
  • Senior Member
  • *****
  • Posts: 13319
  • Family is not an important thing. It's everything.
Re: 86 C10 Fuse panel
« Reply #2 on: November 06, 2014, 11:30:26 PM »
also sometimes fuses can look good even if they are bad
Logged
If you can’t tell yourself the truth, who can you tell it to?~Irish_Alley

When you have eliminated the impossible, whatever remains, however improbable, must be the truth ~Sherlock Holmes
Pages: [1]   Go Up
« previous next »