« previous next »
Pages: [1]   Go Down

Author Topic: Rust spot  (Read 3393 times)

Offline traumajunkie

  • Newbie
  • Posts: 39
Rust spot
« on: February 17, 2015, 07:58:46 pm »
I need some advice, I have found a water leak located just above the ebrake in the corner part of the firewall. I can barely access it from the inside and its almost impossible from the outside. What is the best way to fix this with out cutting a lot. I was thinking drilling it out and using silicone...
Logged
911 Please State Your Emergency

Offline Jason S

  • Senior Member
  • ****
  • Posts: 1561
Re: Rust spot
« Reply #1 on: February 18, 2015, 03:02:22 pm »
Is there any way you can post a photo of the hole or area?
Logged
1973 GMC K2500, Super Custom, Camper Special, 350, TH350, NP203, 4.10's
1974 Chevrolet K10, Custom Deluxe, 350, SM465, NP203, 3.73's

"1) Peace through strength; 2) Trust but verify; 3) Beware of evil in the modern world"

Offline semocoachworks

  • Newbie
  • Posts: 6
  • Newbie
Re: Rust spot
« Reply #2 on: February 19, 2015, 09:34:31 pm »
I had an 84 blazer with a leak up there. I silicones around everything that went through the firewall in that area and took the wiper cowl off to gain access to rust hole. I could barely get to it but it gave me just enough room to silicone over the rust hole. Hope this helps.
Logged

Offline Captkaos

  • OWNER and Administrator
  • Administrator
  • Senior Member
  • *****
  • Posts: 18467
    • http://www.73-87chevytrucks.com
Re: Rust spot
« Reply #3 on: February 19, 2015, 11:01:44 pm »
I would say you need to get under the cowl area and check it if it is leaking from there, or check the windshield area.

http://forum.73-87chevytrucks.com/smforum/index.php?topic=12521.0
Logged
Pages: [1]   Go Up
« previous next »