Author Topic: round port or square port? (Read 5566 times)

markzepp820 · « **on:** March 11, 2006, 10:18:00 am »

I am going to replace my header gaskets and i wanna know if i have round port or square port...

79' C20 350 5.7

DnStClr · « **Reply #1 on:** March 15, 2006, 08:09:00 pm »

The link below will show you an engine made to replace yours, and the ports are round.
www.hiperformer.com/featured_engines/chv_350lb_4.html

markzepp820 · « **Reply #2 on:** March 16, 2006, 03:51:00 pm »

thanks

roundedline · « **Reply #3 on:** March 16, 2006, 05:09:00 pm »

Wonder where my reply to this went....
Or did you post it more than one place..

markzepp820 · « **Reply #4 on:** March 16, 2006, 05:48:00 pm »

hmmmm... wat was your reply roundedline?

roundedline · « **Reply #5 on:** March 17, 2006, 10:32:00 am »

In a nutshell, I basically said if it is anything from a Gen I SBC (up to about 1995) then they will be round. Especially if they are factory heads.

News: