« previous next »
Pages: [1]   Go Down

Author Topic: Centre Caps  (Read 3283 times)

Offline Laderhosen

  • Frequent Member
  • **
  • Posts: 272
Centre Caps
« on: March 29, 2009, 11:55:39 am »
Logged
'82 3/4 ton, 350, th400,
'88 K5 Blazer, 350, 700R4
’98 BMW 328i daily drive
’91 VW Golf Mk 2 with VR6 conv

Offline bmaier

  • Registered Users
  • *
  • Posts: 215
Re: Centre Caps
« Reply #1 on: March 29, 2009, 04:43:42 pm »
Do you have a 2 or 4 wheel drive? If it's 4 wheel it wont fit unless you cut two of the centers out for the front and would also need different lug nuts.

As for whether or not it will fit the stock steels you would have to do some measuring. These center caps may hit that inner dish.
Logged
Are you just gonna lay there and bleed or are you gonna cowboy up?

1979 Chevy Bonanza K10, Shortbox, 350/350, 4" lift, 35's
1979 Chevy Silverado C10, Shortbox, 305/350

Offline choptop

  • Senior Member
  • ****
  • Posts: 2476
  • Extended cab fanatic
    • conversiontrucks
Re: Centre Caps
« Reply #2 on: March 29, 2009, 10:03:34 pm »
You will have to get a set of nuts that have the outer thread on them that fit your wheel studs. I think they will fit then if its a 2wd.
Logged
76 C10 Choptop,76 C10 Swb
85 C10, 85 K10, 85 K20,86 C10,86 K10 (all extended cabs)
86 C30 extended crewcab

Offline Laderhosen

  • Frequent Member
  • **
  • Posts: 272
Re: Centre Caps
« Reply #3 on: March 30, 2009, 03:09:25 pm »
YEah it's 2wd. Was just concerned they might not fit inside the dish.
Logged
'82 3/4 ton, 350, th400,
'88 K5 Blazer, 350, 700R4
’98 BMW 328i daily drive
’91 VW Golf Mk 2 with VR6 conv
Pages: [1]   Go Up
« previous next »