« previous next »
Pages: [1]   Go Down

Author Topic: Drilling hole for power doors  (Read 2721 times)

Offline chronos

  • Registered Users
  • *
  • Posts: 169
Drilling hole for power doors
« on: March 19, 2010, 02:37:28 pm »
Another question. I'm going from manual to full power doors
and have to drill the hole in the door post.
Does the front fender have to come off to do this?
It's hard for me to tell.....hope the answer in NO....lol
Logged

Offline Blazin

  • Blazin new trails!
  • Senior Member
  • ****
  • Posts: 6130
Re: Drilling hole for power doors
« Reply #1 on: March 19, 2010, 03:44:56 pm »
The doors only need to be off. If you look close you will see two little dimples in the a pillar post. Drill them for the screws that hold the boot. Drill a bigger hole for the wires to run through.
Logged
Some people are like Slinkies. Not really good for anything, but they still bring a smile to your face when you push them down a flight of stairs

Offline chronos

  • Registered Users
  • *
  • Posts: 169
Re: Drilling hole for power doors
« Reply #2 on: March 22, 2010, 01:21:19 pm »
Thanks Blazin.....great news
Logged

Offline VileZambonie

  • Global Moderator
  • Senior Member
  • *****
  • Posts: 19169
Re: Drilling hole for power doors
« Reply #3 on: March 22, 2010, 05:48:11 pm »
I'll be doing this on a door tomorrow
Logged
,                           ___ 
                         /  _ _ _\_
              ⌠ŻŻŻŻŻ'   [☼===☼]
              `()_);-;()_)--o--)_)

74 GMC, 75 K5, 84 GMC, 85 K20, 86 k20, 79 K10
Pages: [1]   Go Up
« previous next »