« previous next »
Pages: [1]   Go Down

Author Topic: Heater controls  (Read 4305 times)

Offline hound33

  • Newbie
  • Posts: 8
Heater controls
« on: March 02, 2010, 02:19:57 pm »
I have an 87 k20 4x4, I installed a new heater core, after I was done my controls wont adjust the air flow where I need it i.e. defrost vent etc I know my cables are connected right because I marked them before disassembly any suggestions?
Logged

Offline VileZambonie

  • Global Moderator
  • Senior Member
  • *****
  • Posts: 19167
Re: Heater controls
« Reply #1 on: March 02, 2010, 03:24:11 pm »
Sounds like you didn't hook it up correctly. Check your vacuum actuators, the blend door and make sure the cables are secured in the control head and on the blend door actuator.
Logged
,                           ___ 
                         /  _ _ _\_
              ⌠ŻŻŻŻŻ'   [☼===☼]
              `()_);-;()_)--o--)_)

74 GMC, 75 K5, 84 GMC, 85 K20, 86 k20, 79 K10

Offline hound33

  • Newbie
  • Posts: 8
Re: Heater controls
« Reply #2 on: March 02, 2010, 05:04:09 pm »
I know all my cables and vacume lines are secure but I think I remember(it's been a while since I fixed my core) that I had problems with the blender door when I took out the heater box is it possible to screw up the rod that the blender door swings on? Thanks for your reply!
Logged

Offline VileZambonie

  • Global Moderator
  • Senior Member
  • *****
  • Posts: 19167
Re: Heater controls
« Reply #3 on: March 02, 2010, 08:45:13 pm »
Yes it is
Logged
,                           ___ 
                         /  _ _ _\_
              ⌠ŻŻŻŻŻ'   [☼===☼]
              `()_);-;()_)--o--)_)

74 GMC, 75 K5, 84 GMC, 85 K20, 86 k20, 79 K10

Offline hound33

  • Newbie
  • Posts: 8
Re: Heater controls
« Reply #4 on: March 03, 2010, 06:28:45 pm »
Will I have to get a new heater box? I'f I remember right I think I might have stripped it out at the bottom, I believe the rod is somewhat square at the bottom where you can see it from the outside?
Logged

Offline VileZambonie

  • Global Moderator
  • Senior Member
  • *****
  • Posts: 19167
Re: Heater controls
« Reply #5 on: March 03, 2010, 10:19:00 pm »
Take it apart and see.
Logged
,                           ___ 
                         /  _ _ _\_
              ⌠ŻŻŻŻŻ'   [☼===☼]
              `()_);-;()_)--o--)_)

74 GMC, 75 K5, 84 GMC, 85 K20, 86 k20, 79 K10
Pages: [1]   Go Up
« previous next »