« previous next »
Pages: [1]   Go Down

Author Topic: No Reverse  (Read 3331 times)

Offline 86silverado

  • Newbie
  • Posts: 71
No Reverse
« on: March 08, 2012, 04:46:50 pm »
I just pick up an 87 silverado 3/4ton 4x4. tranny is 700r4 Truck is decent got two beds one rust free and some doors with it, they said tranny wouldnt go into reverse, well got it to my place and when truck is in park motor seems like it has a load on it, and when you put it into reverse it will go forward, goin down road it shifts normal and isnt sloppy, checked fluid and it is full and doesnt look or smell burnt.  my guess is tranny is junk and ideas? somethin stuck?
Logged

Offline werewolfx13

  • Site Supporters
  • Junior Member
  • ******
  • Posts: 841
Re: No Reverse
« Reply #1 on: March 08, 2012, 09:44:38 pm »
Check the shift linkage. My GMC c1500 used to do that after the transmission was put in and the linkage not properly aligned due to a missing clevis pin.
Logged
Chris
'83 Chevy c10 Silverado SWB
'76 Chevy k20 LWB 6.5'x8' Flatbed
“I know that you believe you understand what you think I said, but I'm not sure you realize that what you heard is not what I meant.”

Offline 87454westernhauler

  • Frequent Member
  • **
  • Posts: 453
Re: No Reverse
« Reply #2 on: March 08, 2012, 10:07:26 pm »
when u put the truck in park will the transmission hold it from rolling?
Logged
86 c10 350 sbc 700R4 Daily Driver
79 gmc c20 350 th350
78 k1500 4x4 350 th350

Offline bake74

  • Senior Member
  • ****
  • Posts: 5871
    • Build Thread
Re: No Reverse
« Reply #3 on: March 09, 2012, 06:38:58 am »
     To clarify a point, you said when you put it into reverse it will go forward.  In reverse will it go through all the gears while going forward like it is in drive ?  Or it will just move forward like in gear ?
Logged
#1: The easiest and most obvious solution to any problem is 99% of the time correct.
#2: There is no such thing as impossible, it just takes longer.
  74 k10, 77k10    Tom

Offline 86silverado

  • Newbie
  • Posts: 71
Re: No Reverse
« Reply #4 on: March 11, 2012, 02:01:26 pm »
well in park the truck feels like it has a load on motor like when you normally put it into park it will idle smoother it still feels like it has something holding it back. After i shut it off last night just it idling in park the fluid was really hot. And Bake i havent tried to drive it foward in reverse because it seems like it doesnt wanna go like it should.
Logged
Pages: [1]   Go Up
« previous next »