« previous next »
Pages: [1]   Go Down

Author Topic: has anyone used the DJM spindals?  (Read 4628 times)

Offline 1bad72

  • Newbie
  • Posts: 17
  • Newbie
has anyone used the DJM spindals?
« on: January 09, 2014, 11:25:02 pm »
Looking for a set of drop spindles and was wondering if anyone has used the Djm 3" drop spindles and if they liked them. I'm liking to go 4 or 5" in the front with a flip kit in the rear but my truck was a v6 truck so we will see once the ls moter is set in place ho it looks. ;)
Logged

Offline Rich84

  • Newbie
  • Posts: 50
Re: has anyone used the DJM spindals?
« Reply #1 on: January 10, 2014, 09:31:09 am »
The DJM spindles are fine..I did mine about 2 years ago, no problems. Had to clearance the caliper a bit and should do the lower control arm as well. I would stay away from their flip kit if you were looking at it, heard of problems with it on another board.
Logged

Offline bake74

  • Senior Member
  • ****
  • Posts: 5871
    • Build Thread
Re: has anyone used the DJM spindals?
« Reply #2 on: January 11, 2014, 09:51:47 am »
Logged
#1: The easiest and most obvious solution to any problem is 99% of the time correct.
#2: There is no such thing as impossible, it just takes longer.
  74 k10, 77k10    Tom

Offline 1bad72

  • Newbie
  • Posts: 17
  • Newbie
Re: has anyone used the DJM spindals?
« Reply #3 on: January 11, 2014, 11:36:43 am »
Thanks , I plan on making my own flip kit it is getting a 4/6 drop. I just wasn't sure if DJM made good spindles or not.
Logged

Offline Captkaos

  • OWNER and Administrator
  • Administrator
  • Senior Member
  • *****
  • Posts: 18461
    • http://www.73-87chevytrucks.com
Re: has anyone used the DJM spindals?
« Reply #4 on: January 11, 2014, 11:55:42 am »
I have used spindles from just about every manufacturer out there.  I have had no issues with any of them.  On certain drop amounts you WILL most likely have to clearance your control arms if using 15" wheels (some 2.5" and 3" spindles)
This includes BellTech, DJM, Western and AIM...
Logged
Pages: [1]   Go Up
« previous next »