« previous next »
Pages: [1]   Go Down

Author Topic: Putting factory A/C components in a Non A/C truck  (Read 2798 times)

Offline luketaylor0

  • Newbie
  • Posts: 18
  • 1982 Chevy K10 Scottsdale
Putting factory A/C components in a Non A/C truck
« on: March 27, 2016, 12:04:12 pm »
So I picked up a complete air conditioning setup minus the switch for my 82 K10 for pretty cheap out of an 84 c10, my truck never had A/C. Has anyone done this conversion yet?
Logged

Offline Jason S

  • Senior Member
  • ****
  • Posts: 1561
Re: Putting factory A/C components in a Non A/C truck
« Reply #1 on: March 27, 2016, 12:47:11 pm »
There are several people on here that have done this conversion.  I did one on a '70's truck, the later would be very similar.  The biggest part of the swap is cutting a hole for the A/C plenum and patching the hole where the heater plenum was.

You might want to take a look at this link - It will show the relation of the firewall holes for a heater and factory a/c... 
http://forum.73-87chevytrucks.com/smforum/index.php?topic=21690.msg179454#msg179454
Logged
1973 GMC K2500, Super Custom, Camper Special, 350, TH350, NP203, 4.10's
1974 Chevrolet K10, Custom Deluxe, 350, SM465, NP203, 3.73's

"1) Peace through strength; 2) Trust but verify; 3) Beware of evil in the modern world"

Offline luketaylor0

  • Newbie
  • Posts: 18
  • 1982 Chevy K10 Scottsdale
Re: Putting factory A/C components in a Non A/C truck
« Reply #2 on: March 27, 2016, 11:19:44 pm »
Wicked, thanks! Goina try it out!
Logged
Pages: [1]   Go Up
« previous next »