« previous next »
Pages: [1]   Go Down

Author Topic: Electric brake controller hook up.  (Read 5066 times)

Offline fitz

  • Senior Member
  • ****
  • Posts: 2085
Electric brake controller hook up.
« on: April 22, 2009, 05:40:48 pm »
Has anyone found an easy spot to tie into for the brake wire on an electric brake controller for trailer brakes? I know some newer trucks have a terminal on the fuse block that is only 12V when the brake pedal is pressed. 
I just don't want to cut into the trucks wiring harness if I don't have to. Thanks.
« Last Edit: April 22, 2009, 05:45:41 pm by fitz »
Logged

Offline VileZambonie

  • Global Moderator
  • Senior Member
  • *****
  • Posts: 19174
Re: Electric brake controller hook up.
« Reply #1 on: April 22, 2009, 07:56:06 pm »
If you look at the bulkhead connector you'll find a harness junction below to your rear lighting. Everything is right there
Logged
,                           ___ 
                         /  _ _ _\_
              ⌠¯¯¯¯¯'   [☼===☼]
              `()_);-;()_)--o--)_)

74 GMC, 75 K5, 84 GMC, 85 K20, 86 k20, 79 K10

Offline Irish_Alley

  • Tim
  • Senior Member
  • ****
  • Posts: 13333
  • Family is not an important thing. It's everything.
Re: Electric brake controller hook up.
« Reply #2 on: April 23, 2009, 04:56:58 pm »
i just used that little splicer bock thing that came with the controller and taped right to the brakelight switch then taped the rest right into the wire harness at the end of the bed using the 4 flat connector thats right there. the only wire i had to run was for the brake controller from the cab to the trailer plug
Logged
If you can’t tell yourself the truth, who can you tell it to?~Irish_Alley

When you have eliminated the impossible, whatever remains, however improbable, must be the truth ~Sherlock Holmes
Pages: [1]   Go Up
« previous next »