« previous next »
Pages: [1]   Go Down

Author Topic: Replacing Floor Panel?  (Read 2664 times)

Offline CreativeNotice

  • Newbie
  • Posts: 63
Replacing Floor Panel?
« on: May 13, 2009, 03:44:26 pm »
So yesterday I pulled two rubber mats and one very damp layer of insulation out of the cab. The passenger side has a quarter sized hole about 1.5 inches from the rocker panel.

How should I pursue this? Replace the entire passenger side floor panel or just cover the whole, paint on some rust ready primer and move on?

Logged

Offline ccz145a

  • Senior Member
  • ****
  • Posts: 1393
Re: Replacing Floor Panel?
« Reply #1 on: May 13, 2009, 04:34:51 pm »
the only way to stop it is to cut out the bad and put in new (weld or a strong adheshive) and then coat it with something bullit proof, like chassis saver or por15, no need to replace the whole panel if it's not bad.

Logged
1975 C10 Silverado LWB, 454CID, TH400, 10bolt 3.42
11MPG Downhill w/tailwind (but there ain't no hills here)

Offline CreativeNotice

  • Newbie
  • Posts: 63
Re: Replacing Floor Panel?
« Reply #2 on: May 16, 2009, 12:56:27 am »
wow that por15 looks awesome. Think I'll use that in the engine bay as well. Thanks.
Logged
Pages: [1]   Go Up
« previous next »