« previous next »
Pages: 1 [2]   Go Down

Author Topic: fixing rusted windshield channel  (Read 15964 times)

Offline dvdswan

  • Frequent Member
  • **
  • Posts: 486
  • Newbie
Re: fixing rusted windshield channel
« Reply #15 on: July 15, 2015, 09:06:09 pm »
so last Friday I picked up another windshield and the j/y and went to install it again.  this time I had success.  once I had the bottom set I pulled the sting up the sides and just made sure the glass was either slightly in the rubber or just by it as it got closer to the top.  pulled the cord across the top and the glass popped in. 













here's the cord I used...

Logged

Offline Don5

  • Registered Users
  • *
  • Posts: 229
  • Newbie
Re: fixing rusted windshield channel
« Reply #16 on: July 15, 2015, 10:27:54 pm »
Thanks for posting this and congrats on a job well done. That looks like pretty heavy duty rope too.
Logged
It's been a LONG time since I have been called a newbie. Just sayin....

1979 GMC K15 355, SM 465, 205, 3.73 Dana 44 with a Spartan Locker, 12 bolt Eaton limited slip and 6 inch lift with 36 x 12.50 Super Swamper TSL's.

Offline RAD77C10

  • Newbie
  • Posts: 60
  • Newbie
Re: fixing rusted windshield channel
« Reply #17 on: July 16, 2015, 01:12:39 am »
Looks Great! That was alot easier than changing the cab!
Logged

Offline dvdswan

  • Frequent Member
  • **
  • Posts: 486
  • Newbie
Re: fixing rusted windshield channel
« Reply #18 on: July 16, 2015, 08:00:25 pm »
Quote from: Don5 on July 15, 2015, 10:27:54 pm
Thanks for posting this and congrats on a job well done. That looks like pretty heavy duty rope too.

the rope is like 5/50 cord or paracord.  IIRC I picked it up at Wally World.  its about a 1/4" in diameter.
Logged
Pages: 1 [2]   Go Up
« previous next »