« previous next »
Pages: [1]   Go Down

Author Topic: pcv route  (Read 3801 times)

Offline mikewb

  • Registered Users
  • *
  • Posts: 167
pcv route
« on: August 11, 2008, 07:14:15 pm »
i need a place to hook my pcv valve. i had it run from front on my edelbrock carb but switched it for a holley now no place to run it. soo theres oil being pushed out front of my block somewhere.
Logged

Offline eventhorizon66

  • Senior Member
  • ****
  • Posts: 1909
Re: pcv route
« Reply #1 on: August 11, 2008, 07:15:53 pm »
There is a vacuum port for PCV on a Holley.  I believe it's under the rear float bowl on all holleys.
« Last Edit: August 11, 2008, 07:19:12 pm by eventhorizon66 »
Logged
'85 C10 SWB 350 700R4 TKO600

Offline mikewb

  • Registered Users
  • *
  • Posts: 167
Re: pcv route
« Reply #2 on: August 11, 2008, 07:17:42 pm »
I have my brakes hooked up there
Logged

Offline eventhorizon66

  • Senior Member
  • ****
  • Posts: 1909
Re: pcv route
« Reply #3 on: August 11, 2008, 07:25:09 pm »
I don't see anything wrong with using a 3/8" tee there.
Logged
'85 C10 SWB 350 700R4 TKO600

Offline 82Shortbed

  • Registered Users
  • *
  • Posts: 141
Re: pcv route
« Reply #4 on: August 12, 2008, 01:25:13 am »
Quote from: eventhorizon66 on August 11, 2008, 07:25:09 pm
I don't see anything wrong with using a 3/8" tee there.

Ditto to that.  I had an '80 malibu where I had the brakes and PCV lines T'd together.  I liked the edelbrock when I swapped it then because everything had its own port!
Logged
'82 Custom Deluxe
350, 882s, stock cam...For Now

Offline Captkaos

  • OWNER and Administrator
  • Administrator
  • Senior Member
  • *****
  • Posts: 18461
    • http://www.73-87chevytrucks.com
Re: pcv route
« Reply #5 on: August 12, 2008, 11:20:14 am »
Depending on the intake you have you could move the Vacuum for the brakes to the manifold if you didn't want them together, otherwise you need to Tee it.
Logged
Pages: [1]   Go Up
« previous next »